logo
86-574-88328001
IT

302 Spring Wire - Kinks and Pay-Off Tension Control

302 Spring Wire - Kinks and Pay-Off Tension Control
Proprietà di base
Luogo d'origine: Cina
Marchio: TOPONE
Certificazione: ISO/SGS/RosH
Numero di modello: 302
Proprietà commerciali
Quantità minima di ordine: 1000 kg
Prezzo: Negoziabile
Termini di pagamento: T/T, L/C
Capacità di fornitura: > 1000 tonnellate al mese
Tag:

Filo di acciaio inossidabile

filo per molle in acciaio

ss bobina di filo
Riepilogo Prodotto
2.2mm 302 filo a molla in acciaio inossidabile rivestito di sapone
Attributi personalizzati del prodotto
Evidenziare

302 stainless steel spring wire

,

kink-resistant spring wire

,

pay-off tension control wire

Certificazione:
ISO,SGS,Rosh
Applicazione:
Springs/vite/filo forma/pesca
Diametro:
0.15-12mm
Materiale:
302
Superficie:
Bright/sapone
Nome del prodotto:
Filo a molla inossidabile da 3,5 mm 316
Tipo:
Duro/morbido
Imballaggio:
bobina, bobina
Descrizione del prodotto
Specifiche e Caratteristiche Dettagliate
302 Spring Wire - Kinks and Pay-Off Tension Control Of all the defects that stop a coiler, the kink is the least visible on a certificate and the most expensive in lost time. A kink is a short permanent bend where the wire was folded tighter than its own elastic limit, and it cannot be straightened by tension. It arrives at the feed rolls as a hard spot, jams the tooling, and if it reaches the spring it leaves a notch that fails in fatigue. This page explains where kinks come
Prodotti correlati

Stainless Spring Wire 302 - Marked Splices, Stable Feed

302 Stainless Spring Wire with Marked Splices for Planned Coil Changes Product Introduction Long spring wire coils contain at least one splice, because drawing and annealing equipment works in finite lengths. What matters on a coiler is not that a splice exists, but whether the operator knows where ...

Filo inossidabile 0,15-12 mm, peso al metro e resa

Weight per Metre and Coil Yield on Stainless Wire Wire is bought by weight and consumed by length. The conversion between the two looks like arithmetic, and it is, but three things make the answer differ from the catalogue: diameter enters the formula squared, the density differs between austenitic ...

Filo inossidabile da 0,15-12 mm, durata a fatica da flessione ciclica

Cyclic Bending Fatigue in Stainless Steel Wire: Where Failures Start A wire that survives one bend and a wire that survives a million cycles are two different specifications, even when both are the same grade and the same diameter. Fatigue is a surface and stress-amplitude problem, and the grade ...

Filo inossidabile ricotto 0,15-12 mm, guida per raggio di curvatura

Minimum Bend Radius on Annealed Stainless Wire: A Practical Guide When a drawing specifies a bend, the question behind it is usually whether the wire will crack at that radius. The answer depends on three things: wire diameter, the tensile band of the coil, and where surface defects sit relative to ...