logo
86-574-88328001
IT

Spiral Spring Load Curve - Why Constant Force Varies

Spiral Spring Load Curve - Why Constant Force Varies
Proprietà di base
Luogo d'origine: Cina
Marchio: Topone
Certificazione: ASTM
Numero di modello: 304, 304L, 316, 316L, 430
Proprietà commerciali
Quantità minima di ordine: 1000 pezzi
Termini di pagamento: L/c, t/t, d/a
Tag:

Torion Springs

FORMA DEL CAVO

Estensione per formatura del filo
Riepilogo Prodotto
Molle a spirale inossidabili: la planarità della curva di carico dipende dalla tolleranza dello spessore del nastro, dall'attrito della bobina e dal trattamento preimpostato. 0,15-12 mm, 201-430, verifica del carico su tre punti, dal 1993.
Attributi personalizzati del prodotto
Applicazione:
di acciaio inossidabile
Resistenza alla temperatura:
Alto
Utilizzo:
varie applicazioni
Materiale:
Acciaio inossidabile
Diametro:
0,15 mm - 12 mm
Articolo:
Frigoriferi inossidabili
Lunghezza:
Personalizzato
Descrizione del prodotto
Specifiche e Caratteristiche Dettagliate
Spiral Spring Load Curve: Why Constant Force Is Never Constant A constant force spiral spring is bought on a single number: the load it should produce. On the bench it is measured at one point of travel, and if that point passes, the lot ships. In service, however, the mechanism sees the whole curve, and the curve is where most complaints originate. This article explains what shapes the load curve of a stainless spiral spring, which tolerances move it, and how to write an
Prodotti correlati

Filo per intestatrici a freddo 302HQ con rame per bassa incrudimento

302HQ Cold Heading Wire with Copper for Lower Work Hardening Product Introduction Every cold heading blow hardens the metal a little more. On a part formed in four or five stations, the accumulated work hardening at the head can be the difference between a clean form and a split. 302HQ carries a ...

Filo di acciaio inossidabile 302 - Consistenza del lotto e controllo Cpk

302 Stainless Wire - Batch Consistency and Cpk Control Two deliveries of the same grade at the same diameter can both be inside specification and still cause different problems, because a specification sets limits and does not describe the distribution inside them. One lot may run tightly around the ...

302 Filo percussore rivestito di sapone - Indice della molla e carico

302 Soap-Coated Spring Wire - Spring Index and Load Two springs wound from the same nominal wire can carry different loads at the same deflection. The reason is usually not the grade but geometry: the spring index, and the actual wire diameter inside its tolerance band. Because spring rate depends ...

Filo inossidabile 0,15-12 mm, difetti superficiali e limiti

Surface Defects on Stainless Wire: Naming Them and Setting Limits Surface quality is one of the few wire properties still agreed in words rather than numbers. That is where most disputes come from: two parties say "good surface" and mean two different things, and the argument only starts after the ...